一、搅拌车拖轮是干什么的？

1、 What does the mixer tug do?

答：搅拌车拖轮是个轴承，用这个把罐体支撑起来啊，它是与搅拌车是一体的，辅助搅拌。

A: the tug of the mixer truck is a bearing. Use this to support the tank. It is integrated with the mixer truck to assist mixing.

二、搅拌车液压泵怎么换油？

2、 How to change the oil of hydraulic pump of mixer truck?

答：一般不建议自己换，直接到售后点找人事更换，而且使用的油必须符合要求，不然对设备损害很大，使用寿命也会大大缩短，更换合理标号的液压油。

A: generally, it is not recommended to replace it by yourself. Go directly to the after-sales point to find someone to replace it, and the oil used must meet the requirements, otherwise it will cause great damage to the equipment and greatly shorten the service life. Replace the hydraulic oil with a reasonable label.

三、水泥搅拌车罐体填充率跟罐体的倾角有什么关系？

3、 What is the relationship between the filling rate of the cement mixer tank and the inclination of the tank?

答：目前搅拌车倾角在12度左右，填充率为63%左右。倾角不好测量，填充率也很难计算。目前销售搅拌车都以有效搅拌容积为准。

A: at present, the inclination angle of the mixer is about 12 degrees, and the filling rate is about 63%. The inclination angle is not easy to measure, and the filling rate is also difficult to calculate. At present, the effective mixing volume is the standard for the sale of mixer trucks.

四、搅拌车罐不转，转开了没力而液压油从油箱加油口喷出来是什么原因？

4、 What's the reason why the mixer truck can't turn, and it's powerless to turn it, but the hydraulic oil sprays out from the filler of the oil tank?

答：液压一个进一个回，进没力可能是油泵封闭部分坏了。回油冲，可能是油泵封闭脚垫坏了，换个脚垫看看。

A: the hydraulic pressure enters and returns one by one. The lack of force may be due to the failure of the sealing part of the oil pump. The oil return flushing may be due to the damage of the sealing foot pad of the oil pump. Replace the foot pad and have a look.

五、搅拌车搅拌桶的转速是多少？

5、 What is the rotating speed of the mixing drum of the mixing truck?

答：进料时搅拌筒的转速：6-10转/分；搅拌时搅拌筒的转速：6-10转/分。

Answer: the rotating speed of the mixing drum during feeding: 6-10 rpm; The rotating speed of the mixing drum during mixing: 6-10 rpm.

六、8-12方的搅拌车进料口到地面距离是多少？

6、 What is the distance from the feeding port of the mixer truck of 8-12 square meters to the ground?

答：一般8-12方的搅拌车整车高度大概在3.8米左右，进料口距离地面就有3.5-米左右，具体的根据不同的车型来定。

A: generally, the height of the whole 8-12 square mixer truck is about 3.8 meters, and the distance between the feed inlet and the ground is about 3.5 meters, which depends on different models.

七、水泥自动搅拌车怎么清洗罐？

7、 How to clean the tank of cement automatic mixer?

答：搅拌车配的水箱，每次卸完料后就应该将水放入罐体内，在返回时搅拌行使，到搅拌站后再将水排出接料。罐体外表应该在水箱加水时即可顺便清洗。当然也可以直接用水箱内的水清洗。如果水泥浆已经凝固，罐体内找的清罐，外表凝固用草酸刷洗就行了。

Answer: the water tank equipped with the mixer truck should put the water into the tank after discharging each time, mix it when returning, and then discharge the water after arriving at the mixing station. The surface of the tank should be cleaned when the water tank is filled with water. Of course, it can also be cleaned directly with the water in the water tank. If the cement slurry has set, clean the tank inside and brush it with oxalic acid when the surface is set.

以上就是问题解答的相关内容了，希望能够帮助到大家，如对这一问题还存在任何疑问，都欢迎关注我们网站http://www.sdzkjf.cn并咨询我们的工作人员，将竭诚为您服务。

The above is the relevant content of the question answer. I hope it can help you. If you still have any questions about this problem, you are welcome to follow our website http://www.sdzkjf.cn And consult our staff, will serve you wholeheartedly.