1、 Advantages and characteristics of Zhongke Jufeng automatic loading mixer compared with traditional mixer the independence of automatic feeder: the automatic feeder can be operated independently to complete the functions of loading, mixing, conveying, unloading, etc.

　　2. 自动搅拌车多功能:自动搅拌车取代装载机、混合机、输送机、发电机组等功能;它还拥有自己的水箱，外吸泵，自动上料搅拌机，其中有水供应给搅拌机连续;由于该材料搅拌器可适用于整座山，具有很实用的性能。30度的斜坡很容易攀爬。多角度270度旋转卸货，适合多种不同地理环境。

　　2. Multiple functions of automatic loading mixer: automatic loading mixer replaces loader, mixer, conveyor, generator set and other functions; it also has its own water tank, external suction pump, automatic loading mixer, in which water is supplied to the mixer continuously; because the material mixer can be applied to the whole mountain, it has very practical performance. A 30 degree slope is easy to climb. Multi angle 270 degree rotary unloading, suitable for a variety of different geographical environments.

　　3.自动搅拌车操作简单，只需两个人即可完成生产。司机操作自动程序，其他人做一些辅助工作。

　　3. The automatic feeding mixer is easy to operate, and only two people are needed to complete the production. The driver operates the automatic program and others do some auxiliary work.

　　4、自动上料搅拌机性价比高:自动上料搅拌机，节省装载机、搅拌机、运输车、发电机组、水车等设备的成本和人工成本，节省时间和精力，合理，性价比高。

　　4. High cost performance of automatic feeding mixer: automatic feeding mixer saves the cost and labor cost of loader, mixer, transport vehicle, generator set, water truck and other equipment, saves time and energy, reasonable price and high cost performance.

　　5、自动搅拌车功率大，满马力可适应多种环境。

　　5. The automatic feeding mixer has high power and can adapt to various environments at full horsepower.

　　6. 自动搅拌车节省时间:自动上料搅拌器为自动上料搅拌器的料箱节省少10分钟的上料时间。机器自动化减少了生产时间。从喂食到排出只需12分钟。搅拌罐可旋转270度，搅拌车可将物料向多个方向排出，不需要移动一分钱。

　　6. Time saving of the automatic feeding mixer: the automatic feeding mixer saves at least 10 minutes of feeding time for the hopper of the automatic feeding mixer. Machine automation reduces production time. It only takes 12 minutes from feeding to discharge. The mixing tank can rotate 270 degrees, and the mixer can discharge materials in multiple directions without moving a penny.

　　二、自动搅拌车的规范

　　2、 Safety Specification for Zhongke Jufeng automatic loading mixer1、由于物料搅拌车应实施两级漏电保护，在上班前，先将电源接通，仔细检查，通过空车试验并认为合格，方可使用。试车时应检查滚筒转速是否合适。一般情况下，空车的速度比空车快2~3转(装完货后)。如有较大差异，应调整主动轮与主动轮的比例。

　　1. As the material mixer shall be protected by two-level leakage protection, before going to work, the power supply shall be connected and checked carefully. It can only be used after passing the empty car test and being qualified. During the test run, check whether the drum speed is appropriate. Generally, the speed of an empty car is 2-3 revolutions faster than that of an empty car (after loading). If there is a big difference, the proportion of driving wheel and driving wheel should be adjusted.

　　2. 自动搅拌车滚筒的旋转方向应符合箭头指示的方向。如不正确，应纠正电机接线。

　　2. The rotation direction of the drum of the automatic feeding mixer shall conform to the direction indicated by the arrow. If not, correct the motor wiring.

　　3.检查传动离合器、制动器是否灵活可靠，钢丝绳是否损坏，轨道滑轮是否完好，四周是否无障碍，各部件是否润滑等。

　　3. Check whether the transmission clutch and brake are flexible and reliable, whether the steel wire rope is damaged, whether the track pulley is in good condition, whether there is no obstacle around, and whether all parts are lubricated, etc.

　　4、自动搅拌车应设置在平位置，用方木垫在轮轴前后，使轮胎设置在高跷上，以免跑偏。

　　4. The automatic loading mixer shall be set in the flat position, with square wood pad in front of and behind the wheel axle, so that the tire is set on stilts to avoid deviation.

　　5. 自动加载机完成后与混凝土搅拌或预计停留超过1 h,除了排出剩下的材料,用石头和水摇缸,启动机器,打开它,并删除所有迫击炮坚持冲洗干净后的气缸。桶内不得有水，以免生锈。同时，应清理混合筒外的灰尘，以保持机器的清洁和完整。

　　5. After the completion of the automatic loader, mix with the concrete or it is expected to stay for more than 1 h, except for discharging the remaining materials, shake the cylinder with stones and water, start the machine, open it, and delete all the cylinders after the mortar insists on washing. There shall be no water in the barrel to avoid rust. At the same time, the dust outside the mixing drum shall be cleaned to keep the machine clean and complete.

　　6. 自动搅拌车启动后，要时刻注意混合器各部分的运转是否正常。机器停机后，检查混合器叶片是否弯曲，螺丝是否松动或断裂。

　　6. After the automatic feeding mixer is started, always pay attention to the normal operation of all parts of the mixer. After the machine stops, check whether the mixer blades are bent and whether the screws are loose or broken.

　　7. 下班后，机器不使用时，应切断电源，并锁上开关箱，以确保。

　　7. After work, when the machine is not in use, cut off the power supply and lock the switch box to ensure safety.

　　以上文章由小编整理，未经允许不得转载，如需了解更多关于自动搅拌车厂家及新自料搅拌机信息，请关注本网站。

　　The above article is compiled and sorted by Zhongke Jufeng. It can't be reproduced without permission. Please pay attention to this website if you want to know more about the price information of the auto loading mixer manufacturer and the latest self feeding mixer.