自动搅拌车应安装在坚实平整的地面上,防止因地面下陷发生倾倒。在使用作业前,应按清洁、紧固、润滑、调整、防腐的程序检查机器各系统,并使之符合要求;有事故隐患须及时。下面来讲讲
自动搅拌车使用功能与进出料相关事项。
The automatic mixer shall be installed on a solid and flat ground to prevent dumping due to ground subsidence. Before operation, check all systems of the machine according to the procedures of cleaning, fastening, lubrication, adjustment and anti-corrosion, and make them meet the requirements; Potential accidents must be eliminated in time. Now let's talk about the use functions of the automatic mixer and the matters related to the feeding and discharging.
电力驱动的自动搅拌车,配电设备应安装适当的熔断器及接地装置,以确保电气系统的。
For electric driven automatic mixer, the power distribution equipment shall be installed with appropriate fuses and grounding devices to ensure the safety of the electrical system.
自动搅拌车在运行中,勿使砂石落人机械的运转部分中去,否则,零件易被卡住而损坏。
During the operation of the automatic mixer, do not let the sand and gravel fall into the running part of the machine, otherwise, the parts will be easily stuck and damaged.
进料斗升起后,斗下不得有人通过或停留。
After the feed hopper is raised, no one is allowed to pass or stay under the hopper.
出料前不能无故停车,亦不能加料后启动。入料量不能超过规定容量。
Do not stop without reason before discharging, and do not start after feeding. The feeding quantity shall not exceed the specified capacity.
搅拌工作结束后,要及时清洗自动搅拌车,防止混凝土结块。清洗时,要防止电器设备受潮。清洗工作须在断电后进行,以防止触电。
After the mixing work is completed, the automatic mixer truck shall be cleaned in time to prevent the concrete from caking. When cleaning, electrical equipment shall be protected from moisture. Cleaning must be carried out after power failure to prevent electric shock.
每次充电前用水冲洗进料口,使进料口在充电时保持湿润;
Flush the feed inlet with water before each charging to keep it wet during charging;
装车的同时给随车自带的清洗水箱加水;
At the same time of loading, add water to the cleaning water tank attached to the vehicle;
自动搅拌车装料后冲洗进料口,清理进料口附近残留的混凝土;
After the automatic mixer truck is loaded, flush the feed inlet and clean the residual concrete near the feed inlet;
在施工现场卸料后,冲洗卸料槽,然后在混凝土储槽中加入30-40L的清洗水;车辆返回时,保持混凝土储罐向前缓慢转动;
After unloading at the construction site, flush the discharge chute, and then add 30-40L of cleaning water into the concrete storage tank; When the vehicle returns, keep the concrete tank rotating forward slowly;
下次装车前切记将混凝土储罐内的污水排出,每天结束时,清洁混凝土储罐及进出口周围。自动搅拌车的清洁点确保没有水泥和混凝土结块。更多相关内容就来我们网站
http://www.sdzkjf.cn进行咨询吧!
Before the next loading, remember to discharge the sewage in the concrete tank. At the end of each day, clean the area around the concrete tank and the inlet and outlet. The cleaning point of the automatic mixer shall ensure that there is no cement and concrete caking. More relevant content will come to our website http://www.sdzkjf.cn Consult!
上一篇:自动搅拌车夏季保养重要事项
下一篇:水泥自动搅拌车损坏部位的原因分析