通常我们在维修搅拌车时,只注意底盘的主要部件和上部的三个主要部件。电池也是混合器的非旋转部分。今天,我想和大家分享一下搅拌机电池的保养程序。
Usually, we only pay attention to the main parts of the chassis and the three main parts of the upper part when we repair the mixer truck. The battery is also a non rotating part of the mixer. Today, I would like to share with you the maintenance procedure of mixer battery.
取下水泥自上料搅拌车电池的防尘罩,检查电池和各极引线夹的固定情况。如果没有松动,说明电池正常。用干净的布擦拭电池外部,主要是面板和桩头上容易引起泄漏的灰尘、油和一些白色粉末。
Remove the dust cover of the battery of the cement self loading mixer, and check the fixation of the battery and each pole lead clamp. If not, the battery is normal. Wipe the outside of the battery with a clean cloth, mainly the dust, oil and some white powder that are easy to cause leakage on the panel and pile head.
再次打开电池的注水盖,检查水位是否在正常位置。通常情况下,电池旁边有高、低极限标记供我们参考。它需要仔细观察。如果发现水位低于下限标志线,必须及时加入蒸馏水。如果一次没有蒸馏水,也可以在紧急情况下注入过滤过的自来水。你不能加太多的水。标准是将其添加到行的中间。
Open the water filling cover of the battery again and check whether the water level is at the normal position. Generally, there are high and low limit marks beside the battery for our reference. It requires careful observation. If the water level is found to be lower than the lower limit mark line, distilled water must be added in time. If there is no distilled water at one time, it can also be injected with filtered tap water in case of emergency. You can't add too much water. The standard is to add it to the middle of the row.
检查
水泥自上料搅拌车蓄电池充电是否正常。这可以用三个仪表来检查。具体检查方法是在发动机起动后测量两级蓄电池的电压。电压必须超过13V才能正常工作。如果发现充电电压过低,建议是找检查充电系统。用三次电表也可以,因为目测也可以。
Check whether the battery of cement self loading mixer is charged normally. This can be checked with three gauges. The specific inspection method is to measure the voltage of the two-stage battery after the engine is started. The voltage must exceed 13V for normal operation. If the charging voltage is found to be too low, it is recommended to find an expert to check the charging system. It is also OK to use the three times electricity meter, because visual inspection is also OK.
发动机起动后,打开蓄电池水罩,检查每个电池是否有气泡。如果有气泡,充电系统可能有问题。需要注意的是,检查时会产生氦气,但氦气的化学性质相对稳定,正常情况下没有问题。
After the engine is started, open the battery water cover and check whether each battery has bubbles. If there are bubbles, there may be a problem with the charging system. It should be noted that helium will be produced during the inspection, but the chemical properties of helium are relatively stable, and there is no problem under normal conditions.
That's all for the regular inspection of the battery of the cement loading mixer. You can follow our website at www.sdzkjf Cn for more information!
上一篇:搅拌车的搅拌工作与事后维护
下一篇:搅拌车制动系统的5个须知常识