对于开水泥自上料搅拌车的司机而言,可怕的情况莫过于刹车失灵了。作为基本、重要、核心的主动安全技术,刹车几乎是汽车安全关键中的关键。试想,一部无法停下来的
水泥自上料搅拌车是多么的危险。如何应对搅拌车在行驶中刹车失灵呢?以下一些经验分享给大家。
For the driver of the cement self loading mixer, the most terrible situation is that the brake fails. As a basic, important and core active safety technology, braking is almost the key of automobile safety. Just imagine how dangerous it is for a cement self loading mixer that cannot stop. How to deal with the brake failure of the mixer truck during driving? Here are some experiences to share with you.
刹车失灵的原因:
Reasons for brake failure:
不合理的操作方法导致零件失效,搅拌车的错误操作导致零件失效的原因是驾驶员缺乏驾驶经验。下长坡时,要降低车速,用发动机控制车速,尽量少用刹车,防止刹车片过热,踩刹车时用点刹代替“一脚闷”的方法。
Unreasonable operation methods lead to the failure of parts. The reason for the failure of parts caused by the wrong operation of the mixer truck is the lack of driving experience of the driver. When going down a long slope, reduce the speed, use the engine to control the speed, and use the brake as little as possible to prevent the brake pad from overheating. When stepping on the brake, use the point brake instead of the method of "one foot is stuffy".
严重超载导致制动器失灵,严重超载,搅拌车总质量增加。在重力加速度作用下,车辆惯性增大,直接导致制动失效。超载车辆增加了车辆的总质量,从而增加了车辆的惯性。驾驶超载车辆时,我们必须减速。我们不能不考虑生命安全就匆匆忙忙。
Severe overload leads to brake failure, severe overload, and total mass of mixer truck increases. Under the action of gravity acceleration, the vehicle inertia increases, which directly leads to brake failure. Overloaded vehicles increase the total mass of the vehicle, thus increasing the inertia of the vehicle. When driving an overloaded vehicle, we must slow down. We can't rush without considering the safety of our lives.
切忌惊慌,这是正确处理好事情的前提。一旦发觉汽车刹车失灵,千万不要惊慌失措,否则踩到了油门或者乱打方向都只能雪上加霜。正确的办法是掌握好方向盘,不要随意变线,密切注视周围行车的情况,尽量保持车辆的平稳运行,当然,切忌再踩油门。
Don't panic. This is the premise of handling things properly. Once you find that the car brake fails, don't panic. Otherwise, stepping on the accelerator or hitting the direction will only make things worse. The correct way is to master the steering wheel, do not change the line at will, pay close attention to the surrounding driving conditions, and try to keep the vehicle running smoothly. Of course, do not step on the accelerator again.
然后,启动应急灯,在保持车辆平稳运行的同时,立即启动汽车应急双闪功能,引起周边行驶汽车的注意。这点非常关键,因为这可以明白告诉周围的汽车,你的车处于紧急状态,一般在这种情况下,周围的车都会立即对你的车的行驶状况保持警惕状态,要么避让,要么减速,要么绕行,总之,周围的车的礼让会让你在刹车失灵的情况下容易驾驶得多,而不至于使驾驶员在应付刹车失灵的情况下还要过多的应付周围的危险情况。
Then, start the emergency light, while maintaining the smooth operation of the vehicle, immediately start the emergency double flash function of the vehicle to attract the attention of the surrounding vehicles. This is very important because it can clearly tell the surrounding cars that your car is in an emergency. Generally, in this case, the surrounding cars will immediately keep alert to the driving conditions of your car, either avoid, slow down, or bypass. In short, the courtesy of the surrounding cars will make it much easier for you to drive when the brakes fail, So that the driver will not have to deal with the surrounding dangerous situations when dealing with brake failure.
根据经验,我们把遇险后的动作简单总结为以下步骤:松油门-靠边—抢挡—拉手刹—停车。需要强调的是,为了让车停得更快,要尽可能抢入低挡。更多相关事项就来我们网站
http://www.sdzkjf.cn咨询了解吧。
According to our experience, we can simply summarize the actions after distress as the following steps: release the accelerator - pull aside - grab the gear - pull the handbrake - stop. It should be emphasized that in order to make the car stop faster, try to enter the low gear as much as possible. For more information, please visit our website http://www.sdzkjf.cn Consult and understand.
上一篇:夏季搅拌车发动机走高温尽快处理
下一篇:自上料水泥搅拌车有什么需要注意的