1、 What does the mixer tug do?

搅拌车拖轮是个轴承，用于把罐体支撑起来，与搅拌车是一体的，辅助搅拌。

The tug of the mixer truck is a bearing, which is used to support the tank and is integrated with the mixer truck to assist mixing.

二、搅拌车拖轮是干什么的？

2、 What does the mixer tug do?

一般不建议自己换，直接到售后点找专门的人员更换，而且使用的油需符合要求，不然对设备损害很大，使用寿命也会大大缩短，更换合理标号的液压油。

Generally, it is not recommended to replace it by yourself. Go directly to the after-sales point to find a special person to replace it, and the oil used must meet the requirements, otherwise it will cause great damage to the equipment and greatly shorten the service life. Replace the hydraulic oil with a reasonable grade.

三、搅拌车罐体填充率跟罐体倾角有什么关系？

3、 What is the relationship between tank filling rate of mixer truck and tank inclination?

目前搅拌车倾角在12度左右，填充率为百分之六十三左右，倾角不好测量，填充率也很难计算。目前销售的搅拌车都以有用的搅拌容积为准。

At present, the inclination angle of the mixer is about 12 degrees, and the filling rate is about 63%. The inclination angle is not easy to measure, and the filling rate is difficult to calculate. At present, the mixer trucks sold are subject to the useful mixing volume.

四、混凝土搅拌车罐不转，转开了没力而液压油从邮箱加油口喷出来是什么原因？

4、 What is the reason why the tank of the concrete mixer doesn't rotate and has no force when it is turned, but the hydraulic oil is sprayed out from the oil filler of the mailbox?

液压一个进一个回，进没力可能是油泵封闭部分坏了。回油冲，可能是油泵封闭脚垫坏了。

The hydraulic pressure goes back and forth one by one. The lack of inlet force may be that the closed part of the oil pump is broken. The return oil flushes. The sealing foot pad of the oil pump may be damaged.

五、搅拌车搅拌筒的转速是多少？

5、 What is the speed of the mixing drum of the mixing truck?

进料时搅拌筒的转速是：6---10转/分；搅拌时搅拌筒的转速：6--10转/分。

The rotating speed of the mixing drum during feeding is 6-10 rpm; Speed of mixing drum during mixing: 6-10 rpm.

六、8--12方的混凝土搅拌车进料口到地面距离是多少？

6、 What is the distance from the feed inlet of 8-12 m3 concrete mixer to the ground?

一般8--12方的搅拌车整车高度大概在3.8米左右，进料口距离地面就有3.5米左右，具体的根据不同的车型来定。

Generally, the height of 8-12 square mixer truck is about 3.8 meters, and the feed inlet is about 3.5 meters away from the ground. The details are determined according to different models.

七、水泥搅拌车怎么清洗罐？

7、 How to clean the tank of cement mixer?

搅拌车配的水箱，每次卸完料后就应该将水放入罐内，在返回时搅拌行使，到搅拌站后再将水排出接料。罐体外表应该在水箱加水时即可顺便清洗。当然也可以直接用水箱内的水清洗。如果水泥浆已经凝固，罐体内找专门的清罐，外表凝固用草酸刷洗就行了。

For the water tank equipped with the mixer truck, the water shall be put into the tank after unloading each time, and the water shall be mixed when returning. After arriving at the mixing plant, the water shall be discharged and received. The surface of the tank should be cleaned when the water tank is filled with water. Of course, it can also be cleaned directly with the water in the water tank. If the cement slurry has solidified, find a special cleaning tank inside the tank, and brush the surface with oxalic acid.

以上的精彩内容来自：自上料水泥搅拌车更多的精彩内容来自：http://www.sdzkjf.cn欢迎大家与我们进行交流。

The above highlights come from: self feeding cement mixer, and more highlights come from: http://www.sdzkjf.cn Welcome to communicate with us.