1、 What is a mixer tug for?

搅拌车拖轮是个轴承，用这个把罐体支撑起来，它是与搅拌车是一体的，辅助搅拌。

The mixing truck tugboat is a bearing, which is used to support the tank. It is integrated with the mixer to assist mixing.

二、搅拌车液压泵怎么换油？

2、 How to change oil for hydraulic pump of mixer truck?

一般不建议自己换，直接到售后点找人事更换，而且使用的油必须符合要求，不然对设备损害很大，使用寿命也会大大缩短，应更换合理标号的液压油。

Generally, it is not recommended to replace it by yourself, but go directly to the after-sales point to find professional personnel for replacement. Moreover, the oil used must meet the requirements, otherwise the equipment will be greatly damaged and the service life will be greatly shortened. Therefore, the hydraulic oil with reasonable label should be replaced.

搅拌车上装你应该了解的7个小常识

Seven common sense that you should know about mixing truck

三、水泥搅拌车罐体填充率跟罐体的倾角有什么关系？

3、 What is the relationship between the tank filling rate and the inclination angle of cement mixer truck?

目前搅拌车倾角在12度左右，填充率为63%左右。倾角不好测量，填充率也很难计算。目前销售搅拌车都以有效搅拌容积为准。

At present, the inclination angle of mixer truck is about 12 degrees, and the filling rate is about 63%. The inclination angle is not easy to measure and the filling rate is difficult to calculate. At present, the sales of mixer truck are based on the effective mixing volume.

四、水泥自动搅拌车罐不转，转开了没力而液压油从油箱加油口喷出来是什么原因？

4、 What is the reason why the tank of the concrete mixer doesn't rotate and the hydraulic oil sprays out from the fuel port of the oil tank?

液压一个进一个回，进没力可能是油泵封闭部分坏了。回油冲，可能是油泵封闭脚垫坏了，可以换个脚垫试试。

The hydraulic pressure enters and returns one by one. The inlet force may be due to the broken sealing part of the oil pump. Return oil flush, it may be that the oil pump sealing foot pad is broken, you can change a foot pad to try.

五、水泥自动搅拌车搅拌桶的转速是多少？

5、 What is the rotational speed of the mixing bucket of the concrete mixer truck?

进料时搅拌筒的转速：6—10转/分；搅拌时搅拌筒的转速：6—10转/分。

The rotational speed of the mixing drum during feeding is 6-10 rpm, while that of the mixing drum is 6-10 rpm.

六、8-12方的水泥自动搅拌车进料口到地面距离是多少？

6、 What is the distance between the feeding port and the ground of 8-12 m3 concrete mixer truck?

一般8-12方的搅拌车整车高度大概在3.8米左右，进料口距离地面就有3.5米左右，具体情况取决于不同的车型。

Generally, the vehicle height of 8-12 square meters mixer is about 3.8 meters, and the distance between the feed inlet and the ground is about 3.5 meters, depending on different models.

七、水泥搅拌车怎么清洗罐？

7、 How to clean the tank of cement mixer?

搅拌车配的水箱，每次卸完料后就应该将水放入罐体内，在返回时搅拌行驶，到搅拌站后再将水排出接料。罐体外表应该在水箱加水时即可顺便清洗。当然也可以直接用水箱内的水清洗。如果水泥浆已经凝固，罐体内找的清罐，外表凝固用草酸刷洗就行了。

The water tank equipped with the mixer truck should put the water into the tank after unloading each time. When returning to the tank, the water should be discharged to the mixing station to receive materials. The surface of the tank should be cleaned when the water tank is filled with water. Of course, it can also be directly cleaned with water in the water tank. If the cement slurry has solidified, find a professional cleaning tank inside the tank, and brush the surface with oxalic acid.