Method 1

1、准备好紧急驱动软管，将故障商品混凝土水泥搅拌运输车熄火，卸下液压马达上的高压油管接头。

1. Prepare the emergency drive hose, turn off the fire of the cement mixer truck, and remove the high-pressure oil pipe joint on the hydraulic motor.

2、将救援车熄火，将其液压马达的高压油管卸下，并与故障车上的对应接头用紧急驱动软管相连。

2. Turn off the fire of the rescue vehicle, remove the high-pressure oil pipe of its hydraulic motor, and connect it with the corresponding connector on the fault vehicle with emergency drive hose.

3、发动救援车，将其操纵手柄拨至出料位置，故障车内的商品混凝土即被排出。

3. Start the rescue vehicle, turn its control handle to the discharging position, and the commercial concrete in the fault vehicle will be discharged.

4、紧急驱动完毕后，将驱动软管卸下，并恢复两车原状。

4. After the emergency drive, remove the drive hose and restore the original state of the two vehicles.

方法二：

Method 2

1、若个方法实行有困难，则必须采用以下方法，立即排出商品混凝土。

1. If the first method is difficult to implement, the following methods must be adopted to discharge the commercial concrete immediately.

2、在托轮和滚道之间放入木楔，以控制搅拌筒的旋转，一定要注意安全;将发动机熄火，拆松液压马达的一根高压油管，搅拌筒可自由旋转，控制搅拌筒的旋转，使维修孔转到下部，然后打开维修孔，清理出筒内商品混凝土。此时一定要注意安全，商品混凝土排出完毕后，恢复商品混凝土水泥搅拌运输车原状。

2. Put a wooden wedge between the supporting roller and the raceway to control the rotation of the mixing drum. Be sure to pay attention to safety. Turn off the engine and loosen a high-pressure oil pipe of the hydraulic motor. The mixing drum can rotate freely and control the rotation of the mixing drum to make the maintenance hole turn to the lower part, and then open the maintenance hole to clean out the commercial concrete in the cylinder. At this time, we must pay attention to safety, after the completion of commercial concrete discharge, restore the original state of commercial concrete cement mixing truck.

紧急清理水泥搅拌运输车内商品混凝土是每个水泥搅拌运输车司机都应该会的，在水泥搅拌运输车发生故障的时候，及时清理，将损失降到。

Emergency cleaning of commercial concrete in cement mixer truck is what every cement mixer truck driver should know. When the cement mixer truck breaks down, clean it in time to minimize the loss.